
SB-X270 PC/104+ Single Board Computer
CompuLab LTD.
7
2.2. Features
The "SB Option" column specifies the P/N code of the SB-X270 required for the particular
feature. The "CM Option" column specifies the P/N code of CM-X270 required for the
particular feature. SB-X270 content is the combination of features provided by the attached
CM-X270 and the features implemented on the SB-X270 itself. To have the particular
feature, both the CM and SB options of that feature must be implemented.
"+" means that the feature is always available, regardless of P/N code.
Feature Specification
SB
Option
CM
Option
CPU
SDRAM
Flash Disk
See Features List of CM-X270 module
COM-A Full modem controls, RS-232 levels, RJ11 or DB9 connector
+ +
COM-B Rx/Tx , RS232 & TTL levels, on 100-mil header + B
COM-C Full modem, RS 232/422/485 levels, standard 10-pin header + +
COM-D Rx/TX, RS-232 & TTL levels, on 100-mil header X +
IrDA SIR and FIR modes. Shared with COM-D + +
IDE PIO mode. Derived from local bus. Standard 40-pin header + +
Ethernet
One or two 10/100BaseT Ethernet ports:
1. Module's port - DM9000, local bus interface
2. Baseboard port Realtek RTL8139 controller PCI interface
RJ-45 connector and activity LED's provided in two options:
- From baseboard's front panel
- Through FPC and optional extension module
+
E2
F1
+
E
E,B
LCD Panel
STN and TFT panel support. 51-pos FPC connector for
direct interface to certain TFT panels
L +
CRT Monitor
RGB signals are derived from the TFT interface using
DAC's.
Interface through DB15 on the front panel or through
FPC and optional module
V +
GPIO 9 to 14 lines, on common 100-mil header. + +
PCMCIA &
CardBus
Slots with card guides, for card types I, II and III. Two
options:
- One slot for PCMCIA / CompactFlash (16-bit) card.
- One PCMCIA slot and one CardBus (32-bit) slot
C1
C2
+
B
Comentarios a estos manuales